Skip to content

Baby Tees Jumbo Wheel

Good Morning Stamper Friends,

Well, today has been another very busy day, I started at 10:00 and it's now 2:00 AM and I could probably go for another 3 hours! But I'm not going to, I figure I have tomorrow and what I don't get done will just have to wait till I get back. 

So tonight I was starting to put labels on my swap cards, and discovered it does not matter how much snail you put on the back of a card if there embossed with the square lattice they are NOT going to stay together!   (Grrrr) So I have just went through all of them and put dimensionals on them! That's just a FYI for you, so you don't have to redo your cards!!!

So about a half hour ago, yah like 1:30 I was reaching for my labels and the stupid chair rolled out from underneath me and down I went.  Oh yah, the dogs all came running, did Steve? nope! Only when the dogs would not stop barking did he get up and come down stairs. Yes, I was still sitting on the floor I thought for sure I had broke my arm, but I think it's going to be OK. 

So with being so busy and redoing swap cards I did not get a chance to stamp any new cards tonight, I promise I will share 2 with you tonight.  So I went on the Stampin Connection and pulled this cute card, I just ordered this wheel and can't wait to get it so I can do this card!

Babytees 

Well, I am going to go take some Tylenol PM and go to bed, thanks for stopping by and see you all tomorrow.

Tamie

1 thought on “Baby Tees Jumbo Wheel”

  1. Well I won’t be able to see your post with my coffee tomorrow Tamie, as I hope to be in the air. Plane leaves at 6 a.m. (means I have to get up at 3 a.m.). I too am ordering the Baby Tees jumbo wheel when I get back (I swore I was not going to, but you know what happens when you swearZ). Be safe, you don’t need to be injured at Convention and see you there!!

Leave a Reply

Your email address will not be published. Required fields are marked *